A freshly cut Christmas tree contains a lot of water. The most important thing you can do after bringing it home is keep the base submerged in plain water and protect the tree from excess heat.
- Cut the tree low and straight across at the ranch.
- Before placing it in the stand, make a fresh straight cut of about 1/2 inch, especially if several hours have passed since harvest.
- Put the tree in water as soon as possible after the fresh cut.
- Use a stand with enough capacity for your tree. For many trees, that means at least 1 gallon.
- Check the water every day and keep the trunk base submerged.
- Use plain tap water. Additives are not needed.
- Keep the tree away from fireplaces, heaters, heat vents, and direct sunlight.
1. Cutting Your Tree at Bohling's Ranch
Cut as low and as straight as practical. A straight cut gives you a stable trunk for the stand and leaves room to make a small fresh cut at home if needed.
Cutting is easiest with two people. One person can hold lower branches out of the way while the other saws. A gentle pull away from the saw can help keep the cut open and reduce binding.
2. Getting It Home
- Ask us about tree shaking and netting. Netting can make the tree easier to carry and set up.
- Customers are responsible for final securement and safe transportation of their tree. Follow applicable vehicle and roadway safety requirements before driving.
- If you are not setting the tree up right away, keep it in a cool, shaded, protected place with the trunk in a bucket of water.
3. Make a Fresh Cut Before the Stand
A fresh cut removes the dried or sealed surface at the bottom of the trunk so the tree can take up water efficiently.
- Remove about 1/2 inch from the base.
- Cut straight across, not at an angle or into a V.
- Do not shave bark or outer wood from the sides just to make the trunk fit a stand.
- Place the tree in water promptly after making the fresh cut.
Tip: Drilling holes in the trunk does not improve water uptake. Water temperature is not important, so plain tap water is all you need.
4. Choose the Right Stand
A useful rule is to provide about 1 quart of stand capacity for every inch of trunk diameter. A stand that holds at least a gallon is appropriate for many household trees.
| Trunk diameter | Potential daily water use |
|---|---|
| 3 inches | Up to about 3 quarts |
| 4 inches | Up to about 1 gallon |
| 6 inches | Up to about 1.5 gallons |
5. Check the Water Every Day
- Trees often use the most water during the first several days indoors.
- Check the stand at least daily, and more often at first if the tree is drinking quickly.
- Never let the water level fall below the bottom of the trunk.
- If the stand was dry for a prolonged period and the tree is not yet decorated, another fresh cut can help restore water uptake.
6. Skip the Additives
Sugar, aspirin, bleach, soda, corn syrup, and commercial tree preservatives are unnecessary. Research-based guidance recommends plain tap water, and some additives can increase needle loss.
7. Pick a Cool Spot
- Keep the tree away from fireplaces, radiators, space heaters, heat vents, and strong direct sunlight.
- Redirect a nearby heat vent if it blows directly toward the tree.
- A cooler location slows drying and reduces water demand.
8. Decorate Safely
- Use LED or other low-heat lights.
- Inspect light strings and replace damaged or frayed sets.
- Turn tree lights off when you leave home or go to bed.
Safety: Keeping the tree well watered helps reduce drying. If the tree becomes very dry and the needles are brittle or falling excessively, remove it from the house.
9. After the Holidays
- Check your municipality for tree recycling or curbside pickup.
- Evergreen branches can also be used as winter cover around some outdoor plants or near bird-feeding areas.
- Never burn any part of a Christmas tree in a fireplace or wood stove.
Care guidance on this page follows recommendations from the National Christmas Tree Association and university extension resources. Have a specific question? See our FAQ.
